Learn how to pair your Arccos sensors for the first time with our comprehensive step-by-step guide, ensuring accurate shot tracking from the start.
Pairing your sensors in the Arccos app is easy with this step-by-step process. Once your sensors arrive, you can begin by:
- Peeling the sticker off each sensor
- Twist all sensors into each club and tighten them until they’re securely fit. The all black sensor is specific for your putter. Green sensors can be used on any other clubs.
- Store: Return all clubs to your bag to avoid cross pairing. Sensors are not active when stored in bag.
Once all of your clubs are returned to your bag (with a sensor on each), you can pair your sensors in the app by following these steps:
- Select ‘Manually Select Clubs To Pair’
- Select Clubs: Select all clubs you will be pairing
- Select Sensor Type: Select Smart Sensor / Smart Grips
- Remove and Pair: Take one club out a time to be paired out of your bag, place the sensor under your phone's camera to pair.
- Paired and continue: ‘Powered by Arccos’ and Club Type will light up all Green once paired. Continue with other sensors
Notes: If a club does not immediately pair after 10 seconds please flip the sensor down to the ground for 15 seconds and then flip back up with good lighting.
- In order to pair, Arccos must have access to your phone's camera, microphone and bluetooth.
- No other devices may be paired with your phone via bluetooth at the same time